Command Line Options
You can use the command line to modify the way Dynam-EC runs at start up:
|
Command line option |
Description |
|---|---|
|
/SIM |
Runs Dynam-EC in Simulation mode. An entry to run Dynam-EC in simulation mode is automatically created in the Start > All Programs at installation (see Starting Dynam-EC From the Start Menu). |
|
/ADMIN |
Runs Dynam-EC in Administrator mode. Administrator mode enables a system administrator to place restrictions on user actions through a number of additional settings. These settings are saved in the project file (provided that you save the file while in Administrator mode). |
|
/LAN2 |
Uses the secondary LAN’s IP addresses to connect to the linked set (the group of linked matrices to which Dynam-EC connects. This does not include PiCo). |
|
/ASSOCIATED-PANEL |
Allows the system administrator to set up a command line specifying the associated panel to be used. The format of the command line is: /ASSOCIATED-PANEL=PORT.<system number>.<port number> Example: /ASSOCIATED-PANEL=PORT.1.3 for port 3 on system 1. |
|
/ASSOCIATED-METER-PORT |
Allows the system administrator to set up a command line specifying which port on the matrix is connected to the PC audio input. This enables Dynam-EC to meter an audio level without using an LMC-64 interface card. The format of the command line is: /ASSOCIATED-METER-PORT=PORT.<system number>.<port> Different Dynam-EC PCs may use the same layout file (but with different ports). |
|
Configuration file |
Including a system configuration path and filename within/outside (as required by your operating system) the quoted command line causes Dynam-EC to automatically load that system configuration file when it is run. Either a Dynam-EC Information File (*.hxdeci) or a EHX Project File (*.hxn) may be supplied, for example C:\Program Files\ClearCom\ Dynam-EC \filename.hxdeci |
|
Project file |
Including a Dynam-EC project (layout) path and filename (*.ccr) within/outside (as required by your operating system) the quoted command line causes Dynam-EC to automatically load the project (layout) file when it is run. |
Project files (palette and canvas screen layouts) are saved in Dynam-EC as *.ccr format files. You can associate the *.ccr filename extension with Dynam-EC, so that clicking a *.ccr file automatically starts the program.